|
|
 |
| Technical Specifications |
| Physical Properties |
Test Method |
Unit |
InteFoam White |
InteCel White |
InteCel PW (Tan) |
| 12mm |
19mm Embossed |
19mm |
| Specific Gravity |
ASTM D792 |
g /cm3 |
0.62 - 0.66 |
0.46 - 0.50 |
0.70 - 0.75 |
| Shore D Hardness |
ASTM D2240 |
D |
50 |
55 |
60 |
| Water Absorption |
ASTM D570 |
% |
0.15 |
0.20 |
0.25 |
| Flexural Modulus |
ASTM D790 |
psi |
140,000 |
130,000 |
180,000 |
| Flexural Strength @ yield |
ASTM D790 |
psi |
3,500 |
2,800 |
3,800 |
| Nail Hold |
ASTM D1761 |
Lbf/in |
65.4 |
70.7 |
109.0 |
| Screw Holding Strength |
ASTM D1761 |
Lbf/in |
380 |
401 |
749 |
| Coefficient of Linear Expansion |
ASTM D696 |
in/in/°F |
3.5 x 10-5 |
3.5 x 10-5 |
2.5 x 10-5 |
| Heat Distortion Temperature |
ASTM D648 |
°F |
140 - 150 |
135 - 145 |
145 - 155 |
| Weight |
|
lbs/cu in |
0.02235 - 0.02345 |
0.01633 - 0.01775 |
0.02485 - 0.02663 |
|
The information contained herein is true and accurate to the best of our knowledge. All recommendations and suggestions are made without guarantees. This information is to be used by individuals with technical skill at their own discretion and risk. Because conditions of use are beyond our control,
World-Pak Division, Inteplast Group. makes no warranties, expressed or implied, and assumes no liability in connection with the use of this information. The information is subject to change without notice. Note: The above properties may vary due to different sheet thickness. 0107.2008
|
|
|
|
Technical Specification
